Curb flashing
Molded boots on pipes and wrapped curbs under equipment so leaks do not start at the details.
Flat Roofing
TPO Roofing Park Ridge, NJ
TPO roofing in Park Ridge is a white single-ply membrane rolled over insulation and heat-welded at every seam, which turns the whole roof into one continuous sheet with no glued laps. Dial (551) 390-0358 to talk through a TPO roof with a local roofer.
TPO, short for thermoplastic polyolefin, is a single-ply roofing membrane made for roofs that are flat or close to it. Rolls come in several widths and thicknesses, with 60 mil a common middle choice and 80 mil used where the roof sees more wear. Its seams are welded with hot air, so the overlap becomes part of the sheet rather than a glued joint that can let go.
The membrane is only as good as the details around it. A seam welded too cold, a corner patch skipped at a curb or edge metal that was never sealed will leak long before the sheet wears out. Tapered insulation and crickets that move water to the drains or scuppers keep the membrane from sitting under standing water.
TPO Roofing is often paired with tpo roof repair and flat roof installation, depending on the cause.
Dealing with this in Park Ridge, NJ right now? Call (551) 390-0358 and describe the problem to a roofer who works in Park Ridge.
Call nowThe process
How a TPO roof is installed
A TPO roof is built in layers, and each one has a job.
Survey the old roof
Before anything is ordered, the roofer cuts a small sample through the roof to see what is underneath and probes for wet insulation. Codes generally allow no more than two roof systems, so a roof that already has two must be torn off.
Get down to a sound base
Old roofing is removed where needed, damaged decking is replaced and the surface is cleaned and made smooth. Where the old roof stays, a recovery board goes down first so the TPO does not ride on gravel or blisters.
Install insulation boards
Rigid insulation, usually polyiso, is fastened or adhered over the deck, often in tapered boards that pitch water toward the drains. Many energy codes require a minimum insulation value when a roof is replaced, so this layer is planned to meet it.
Secure the sheets
The TPO sheets are rolled out and either mechanically fastened with plates and screws hidden in the seam laps or fully adhered with membrane adhesive. Adhered sheets resist flutter in high winds, and fastened systems suit large open roofs.
Heat-weld every seam
Seams are welded with hot air, using a walking welder on long runs and a hand gun with a roller at corners. After welding, the roofer drags a probe along the seams to catch cold or skipped spots.
Flash every detail
Penetrations get molded boots or field-built flashing, curbs are wrapped and walls are flashed up and capped. At the perimeter, coated edge metal is installed so the membrane welds to it instead of relying on sealant.
What is included
What goes into a TPO roof
Core cut
A core cut or moisture scan of the existing roof before the new roof is planned.
Edge metal
Coated metal at the perimeter and around drains to hold the sheet down in wind.
Insulation boards
New insulation boards sized for the energy code so water moves off instead of ponding.
TPO sheets
White TPO membrane in the chosen thickness with every seam hot-air welded and probed.
Related service
TPO Roof Installation Park Ridge, NJ
For a brand new low-slope roof, the important decisions come before the first roll is opened. The deck, the drain locations and the insulation thickness are set first, then the attachment method is chosen to suit the wind exposure.
Residential TPO installation in Park Ridge tends to mean smaller roofs: additions, carports, dormers with little pitch and flat sections behind a parapet. Below the minimum pitch for shingles, a welded membrane is far more reliable. The tricky part is the tie-in to the shingled roof, which has to be lapped so water flows over the TPO.
Related service
TPO Roof Replacement Park Ridge, NJ
A TPO roof replacement comes into play when repairs stop holding because the sheet or the insulation under it has worn out. An infrared or capacitance scan helps map wet areas so only the damaged insulation is replaced. Wet insulation left in place loses its value and can rust fasteners and steel decking from below.
If the existing roof is one layer and mostly dry, a recover with a new cover board and TPO can be an option. Once a building already has two roof systems, the next roof has to start from the deck.
Related service
PVC Roofing Park Ridge, NJ
Like TPO, a PVC roof is a white or light-colored single-ply sheet whose seams are welded with hot air. PVC handles fats, oils and some chemicals that can soften other membranes, so it often goes on restaurants and food plants.
A roofer needs to know whether a white roof is PVC or TPO before patching it, since the two do not weld to each other. For a Park Ridge roof with no grease or chemical exposure, TPO is often the simpler choice, while PVC earns its place where those exposures exist.
Local help
TPO Roofing Near Me
Around Park Ridge, TPO goes on everything from shopping centers to the flat roof over a back porch: older homes with flat sections and newer buildings with long, low roofs both end up with it. From Park Ridge out to Woodcliff Lake, Montvale, Hillsdale and Saddle River, the mix of older low-slope sections and newer commercial roofs means every job starts with a look at what is already there, so it pays to plan the drainage and the details as carefully as the membrane itself.
Searching for tpo roofing near me from Park Ridge or Woodcliff Lake, Montvale, Hillsdale and Saddle River? Call (551) 390-0358 to talk to a roofer who works in your part of town.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Park Ridge, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why act early
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Park Ridge
Local roofers see the same roofs and storm damage across Park Ridge and nearby towns.
Know what happens next
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about tpo roofing
Can TPO go over my existing roof?
A survey of the old roof answers that question. A recover over a single, dry roof is usually possible. With two layers already in place or trapped moisture, a tear-off is the right call.
Is a TPO roof good for a house?
TPO works well on the low-slope parts of a house, such as porches, additions, garages and flat sections behind parapets. For the steep parts of the roof, shingles or metal remain the norm. The key on a house is the tie-in where the TPO meets the shingles or siding.
Why are TPO roofs white?
The white surface reflects a large share of the sun instead of absorbing it. That lowers roof temperatures and can reduce the cooling load in the rooms below, especially with good insulation under it. Dirt buildup slowly reduces the effect.
How long does a TPO roof last?
Most TPO roofs last roughly 15 to 30 years when they are installed and maintained well. An 80 mil sheet on a roof that drains well and sees little traffic tends to outlast a thin sheet on a roof that ponds.
How does TPO compare to EPDM rubber roofing?
Each has its strengths. TPO is white and reflective with heat-welded seams, while EPDM is a black rubber sheet whose seams are joined with tape or adhesive. Many roofers favor TPO where cooling matters and EPDM where a simple, flexible membrane is wanted.
More questions? Call (551) 390-0358
Related services
TPO Roof Repair
Repairs for open seams, punctures, failed flashings and wet spots on TPO roofs, done after the leak source is traced.
Learn moreFlat Roof Installation
New flat roofs built with real slope, insulation, a cover board and a membrane suited to the building, with every wall, curb and penetration flashed properly.
Learn moreCommercial Roofing
Roofing work for business, institutional and multi-family buildings, from single-ply membranes to metal and coatings.
Learn moreRubber Roof Installation
New EPDM rubber roofs laid in wide sheets over insulation and a cover board, with primed and taped seams, with as few seams as the roof allows.
Learn more
Looking for something else?
See all roofing servicesNeed tpo roofing in Park Ridge, NJ?
Call (551) 390-0358 to talk to a roofer serving Park Ridge, NJ.